Banner
Equipment and accessories

The construction and function of TIMBO painting plants meet the relevant
German and European safety regulations for the processing of conventional
and water-based paint systems.


1. Booth Shell

The double wall panels are made of steel sheet, thickness 50 mm, inside
and outside white, insulated with non-combustible rock wool. They have a
tongue and groove interlocking system for quick assembly.

 

2. Filter Ceiling

The filter ceiling is also made of fully insulated sandwich panels in white
colour with filling of mineral rock wool. The ceiling filter has a quick change
system so that one person only is needed for exchange of filters.

 

3. Lighting

The ceiling lights consist of units with 4 x 58 W lamps with electronic ballast.
The units are mounted at 45°, protected with safety glass towards in-cabin
room, and hermetically sealed, according to IP 54, Zone 2.
The side lights consist of 2 x 58 W lamps and are mounted vertically in the
side walls.

 

4. Aggregates

For the aggregates directly-driven radial ventilators are used with high
efficiency. The motors are from Siemens or ABB.
Depending on requirements and structural possibilities the aggregates
may be positioned at one side or behind the booth as well as
space-saving above the booth.

 

5. Heating System

For heating oil or gas burners can be used with indirect burning via heat
exchanger, or also hot water or steam registers.
The optimum heating is provided by direct firing with gas surface burner
with an efficiency of ca. 100%.

 

6. Control System and Adjustment

TIMBO spray booths are equipped with following components for
adjustment of the unit:
- Change-over damper for automatic change-over of the system from
painting phase to evaporation and drying operation.
- Exhaust air valve for regulation of the booth pressure, adjustable by 
servo-motor.
- For evaporation of water-based paints the system is equipped with an
intermediate drying feature.
- Solvent pipe in galvanised execution with air-stop device for air flow
adjustment during drying process, with flap valve, driven by servo-motor.
- Temperature electronically controlled by temperature sensor.
- Filter control by manometer with direct indication.

7. Energy Saving Feature

To save energy, the booths our booths may be equipped optionally with
Vacon frequency converters with sensorless vector control, integrated PLC
functions and with an energy saving switch to hang up the spray gun and
to change to the energy saving level (see also under "News").