Saving engergy – Protecting the environment!

Most of energy is required in the painting process. One can assume however that max. 50% of the time involved in the spray booth is used for the mere painting process; min. 50% are required for non-painting time.

In a conventional spray booth the equal amount of energy is produced continuously, i.e. also in times in which the aggregates are required to run, but not for painting process.

When using our energy saving circuit in connection with frequency steering, you can save energy and operating costs as well and beyond that you protect the environment.

During the auxiliary process times in which not the full amount of air flow and consequently not the full heating capacity is required, the energy saving circuit will be activated. The driving motors are set to a reduced performance of 40 % of the maximum power. Standby mode.

Additionally TIMBO spray booths offer two different power levels in the particular working processes: partial load (60 – 70%) and full load (100%). For painting of singular small parts the level „partial load“ may be used whereby further energy saving is achieved.

The equipment of your spray booth with our energy saving circuit in connection with frequency converters provides a number of further advantages to you:

•    Reduction of power consumption by the elimination of current and voltage peaks during start of the fan motors.

•    Demand-oriented adjustment of the fan capacity, no mechanical air throttle required.

•    Saving of heat energy

•    Automatic control of booth pressure by integrated SPS controller.